a***@gmail.com
2020-07-25 13:04:00 UTC
Need some help folks. Purchased a 2000 elite Ch80 and replaced carb, air filter, oil, Battery, and spark. Scooter would start up Idle. Giving gas would result in it stalling. Eventually would allow for full throttle. It would ride fine for the most part but this would happen on start up each time. Then the scoot died at full speed and left me stuck. I thought maybe it was particulates clogging fuel lines or fuel filter. Anyhow, put about 1000 miles on it and eventually it stalled and I can’t get it back up and running. I changed out the petcock vacuum valve, fuel lines, and fuel filter. It will start and idle but as soon as you turn the throttle, it dies. I checked for cracks in manifold leading from carb to engine but didn’t see an issue. Changed out spark again but no luck. Running out of ideas and could use some suggestions. I did take off air filter and play around with throttle. I noticed a few drops of fluid dripping out of the air inlet leading to carb. I am not sure if that indicates an internal gasket leak somewhere. I’ve read treads about this issue but it doesn’t seem like it is was solved